Figure 5 – MTD 24635A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
.1 I'l
•'
‘ .* ’•’ ■' ■,■'■ ■'
FIGURE 5
3.
Block the frame of the unit on the left hand side.
Remove the left wheel by removing the cotter pin
and flat washer. Slide wheel off. See figure 6.
COTTER PIN
FIGURE 6
4.
Using a 1/2" wrench, remove the right and left
hand side covers. See figure 7.
LEFTSIDE COVER^
^
-------
\
—
RIGHT SIDE-
COVER
FIGURE 7
,V- -
5.
Remove the 5-1/2" bolt and spacer, located on the
left hand side of unit, which act as a belt keeper.
Two 9/16" wrenches are required. See. figure 8.
FIGURE 8
6. Remove the two idler pulleys as shown in figure
9. Two 9/16" wrenches are required.
FIGURE 9
7. Hold the engagement lever in the forward positio.
(spark plug wire must be disconnected). Pull the
recoil starter rope to rotate the chain until the
master link can be located. Remove the master
link and chain. See figure 10.