MTD 24635A - Manual (Page 4)

ASSEMBLY
NOTE
This unit shipped WITHOUT GAS-
SOLI NE or OIL. After assembly, see
separate engine manual for proper fuel
and engine oil recommendations.
1. Remove the log splitter, loose parts, and literature
from the carton. Make certain all parts and
literature have been removed before the carton is
discarded.
2. Thread the engagement handle into the engage­
ment handle bracket as shown in figure 1.
t\GACf N'lF NT HANDLE
I
FIGURE 1
OPERATION
1 .
2 .
5.
NOTE
Refer to engine manual packed with
log splitter for complete instructions
for the care and maintenance of
engine. READ DIRECTIONS CARE­
FULLY.
Fill sump with oil as instructed in the separate
engine manual.
Fill fuel tank, using clean, fresh, regular grade
automotive gasoline. Fill tank completely.
Before operating log splitter for the first time,
lubricate the two large screws on the wedge and
screw assembly with engine oil. Screws must be
oiled at least every two operating hours or more
often if necessary.
Start engine as instructed in the separate engine
manual.
To stop engine, move throttle control lever to
STOP position. Disconnect and ground the spark
plug wire to prevent accidental starting while
equipment is unattended.
USING YOUR LOG SPLITTER
NOTE
Reference to right or left hand side of
the unit is determined when standing
behind the unit, at the engine.
Your log splitter is designed for safe, efficient
operation. CARE, OF COURSE, MUST BE EXER­
CISED THAT HANDS ARE KEPT AWAY FROM
MOVING PARTS.
Engagement handle has three positions: (See figure 2)
Forward—Wedge moves toward engine.
Neutral—Wedge stops in place.
Reverse—Wedge returns.
NOTE
When the engagerrtent handle is
released, it will automatically return
to "NEUTRAL" position.
FIGURE 2
Maximum length that can be split is 24".
1. Set throttle at maximum speed.
2. Place log on frame assembly.
3. Stand beside the engagement handle on the left
side of the unit.
4. Move engagement handle forward until log is split,
then release handle.
NOTE
After the log is split, do not keep the
engagement handle in the forward
position or the wedge assembly will be
jammed.
5. Move the engagement handle to the reverse
position to return ram.