Troy-Bilt GTX 20 - Manual (Page 25)

Maintenance (continued)
Maintenance Chart
INTERVAL ITEM SERVICE
Daily
Transmission Oil Check
Battery Fluid Check
Engine As Required
Air Intake Screen Check
Engine Oil Level Check
First Engine Oil and Filter Replace
5 hours Transmission Oil Filter Replace
Every Air Filter Pre-cleaner Clean
25 hours Transmission Cooling Fins Clean
Tires Check lor wear and
air pressure
Brake Check tor wear and
adjustment
Every Engine Oil Change
50 hours Engine Oil filter Change
Engine Cooling Fins Clean
Every Air Filter Element Replace
100 hours Transmission Oil Filter Replace
Fuel Filter Change
Spark Plug Replace, clean, reset gap
Transmission Oil Replace
Lubrication Chart
Item Frequency Type of Lubrication Amount Required
Engine
Crankcase
Firsts
hours
See oil recommendations
chart
Without filter 1.5 qts
(1.4 L) With filter add
additional
MZ
pt. (0.24 L) 25 hours
& 50 hours
Lubrication intervals vary
with operating conditions
and type of oil used
Hydrostatic
Transmission
Check Weekly
or 30 hours.
Change when
oil is dis­
colored, dirty
or after
100 hours
Oil -
Part No. 1738157
(Benzoil Gear Hydro Oil)
Alternate Oils - Mobil 423,
Amoco 1000 or Texaco TDH
Fill to within safety
operating zone
Front
Wheel Spindles
25 hours or
end of season
Multi-purpose grease
As required
Front Axle
Pivot
25 hours or
end of season
Multi-purpose grease
As required
NOTE: A hand type grease gun is recommended when greasing your unit. High pressure type grease guns couid cause damage
to the fittings and bearing seals. Lubricate ail linkages, levers and pins not equipped with grease fittings, with an oil can once
each week. More often depending on operating conditions.
25