Ariens 924071 - Manual (Page 16)

ASSEMBLY & PRE-SERVICE
tire chains are used, a pressure of 20 PSl is recom­
mended for proper operation.
BELT ADJUSTMENT
Check the position of the belt fingers on the engine
sheave and the alignment of the sheaves. Adjust accor­
ding to "REPLACEMENT OF TRACTION DRIVE BELT”
section of this manual.
DRIVE CHAIN ADJUSTMENT
If the Sno-Thro is difficult to push because of tight or
interferring drive chain, readjust as described in
"DRIVE CHAIN ADJUSTMENT” section of this
manual.
HEADLIGHT INSTALLATION
Refer to instructions provided in the carton for
headlight assembly.
REGISTRATION
Fill out pre-warranty registration card and mail to
Ariens Company. Warranty will only be registered
under the model and serial number found on the serial
number label (also stamped into the frame of the unit).
Add serial numbers to this page.
DELIVERY
1. Instruct the customer on the operation of the Sno-?'^^
Thro. Emphasize safety and discuss the safety in­
formation in the Owner's Manual.
'
2. Advise customer to change oil in the engine
crankcase after the first two hours of operation.
3. Explain how to perform the recommended lubrica­
tion and periodic service.
4. Explain maintenance and adjustment instructions.
5. Demonstrate how to mount and dismount at­
tachments.
6. Make certain the customer has his Owner's
Manual and Engine Instructions.
7. Explain Ariens Warranty Policy. Fill out and return
Ariens Warranty Registration Card.
SERIAL NUMBER - SNO-THRO
(Plate Located on Rear of Frame)
SERIAL NUMBER - ENGINE
(Stamped into top of Engine above Recoil Start)
A message to the Ariens customer...
Welcome to the world of Ariens equipment. We are pleased that you have selected Ariens and sincerely believe you have pur­
chased the best equipment available. The care you give your new Ariens equipment will greatly determine the satisfaction and ser­
vice life you will obtain from it. Use this manual and the engine manual supplied, as your guide. By observing the instructions and
suggestions in these manuals, your Ariens equipment will serve you well for many years.
Your Ariens dealer will be happy to supply any service or advice which may be required to keep your Ariens equipment operating at
peak efficiency. He stocks genuine Ariens parts and lubricants; manufactured with the same precision and skill as the original
equipment. His factory trained staff is kept well informed on the best methods of servicing Ariens equipment and is ready and able
to serve you. If engine repairs or services are required, they can be obtained from an Ariens dealer or from an authorized engine
manufacturer’s service station. If service is required, be prepared to supply the service person with the Model Number and Serial
Number of the equipment and the engine, as well as a full description of the problem encountered.
16