Ariens PRM-10000 - Manual (Page 43)

13. ARIENS SNO-THRO DRIVE ADJUSTMENTS
When making friction wheel adjustments, first
check position of the clutch handle, as this affects the
pressure being applied to the friction wheel. Adjust
clutch handle so it is positioned as shown in Figure 7
or 8.
With clutch handle position correct, proceed with
the adjustment of the friction wheel as follows:
Ariens Sno-Thro Drive Adjustments
Clutch Handle
Parallel
Clutch
Rod
Clutch Handle
Disengaged
Nylon Block
Parallel
Clutch Handle
All the
Way Up
Clutch
Rod
Clutch Handle
Disengaged
Nylon Block
Model 924013 and
all 922000, 910000 Models
Models 924016, 924018, 924020,
924022, 924024, 924026, 924027
FIGURE 7 FIGURE 8
MODEL YEAR PROCEDURE ILLUSTRATION
910006 6-24"STD.
910007 7-Tractor
910008 7-24" DIF.
910010 8-32" DIF.
910014 7-24"STD.
910016 8-24"STD.
910018 8-24" DIF.
(Serial No. 000101-
002000 )
910021 8-24" DIF.
72-73
72-73
72-73
72-73
72-73
72-73
72-73
72-73
Tip machine forward. Remove cover and shift to
4th speed. With clutch handle in up position rotate
drive disc and friction wheel until the closest point
is found at (A). Adjust nuts (B) until you have a .020
gap at point (A) and tighten nuts (B).
■NOTEi
These models do not accept the 510022
spring loaded adjustment link assembly.
Adjust per this procedure.
-mr ^-%T-
910018 8-24" DIF.
(Serial No. 002001
& up)
910019 6-24" DIF.
910020 8-24"DIF.
73-74 Tip machine forward. Remove cover and shift to
neutral. Return machine to wheels. Depress clutch
handle and tie down. Loosen set screw (A). Turn
adjusting rod (B) and rotate friction wheel until it
contacts the drive disc. Release clutch handle and ^
turn the adjustment rod (B) 2 turns in (clockwise)