Caring for your machine, Removing and replacing bobbin case, To remove bobbin case – SINGER 6212 User Manual
Page 33: To replace bobbin case, Section 7. caring for your machine
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. CARING FOR YOUR MACHINE
REMOVING AND REPLACING BOBBIN CASE
Before cleaning or adjusting the machine, disconnect electrical power cord.
• Raise presser foot and needle.
• Open slide plate and remove bobbin.
• To remove the bobbin case, the nee
dle plate must be removed first.
Lift needle plate (1) from right corner
and slide out from under foot.
To remove bobbin case
• With a small screwdriver, turn bobbin
case holder (2) to the rear as far as it
will go.
• Lift out bobbin case.
To replace bobbin case
• Guide forked end (3) of bobbin case
under feed (4).
• Draw rim of bobbin case under slide
plate (5).
• Turn lever (2) forward as far as it will
go, locking bobbin case in place.
NOTE: After locking case in place, be
sure it is not tight, but can move slightly.
Turn the hand wheel towards you to
check to make sure It is properly
replaced.
•
To replace needle plate, slide it
under pin (6) and push it to the left.
• Press needle plate down in place.
• Insert bobbin and close slide plate.
31