Attaching the button, Attaching a button – SINGER 6212 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ATTACHING THE BUTTON
Flat buttons can be sewn on quickly and easily using the plain zigzag stitch. A
special button sewing foot (H), may be purchased at your sewing center.
RECOMMENDED SETTINGS
Stitch Selection; Zig-Zag Stitch #3
Needle Position:
Stitch Width: To suit Button
Foot: Button Sewing (H)
Needle Plate: General Purpose (A)
Attach Feed Cover (F)
Before you can attach a button, the
bobbin thread must be brought up
through the hole in the feed cover.
1. Set stitch width at i , and needle
position selector at ^ . Position
button under foot and lower and
needle into the center of the left
hole. Lower the foot. Turn hand
wheel toward you until needle
rises out of button and is above the
foot.
2. Move stitch width selector until
needle is over the other hole in the
button. Then, when you begin to
stitch, the needle should enter into
the right hole of the button. Take six
or more zig-zag stitches to attach
button and finish with the needle on
the left side.
3. To fasten stitching, adjust width to
( i ), and take three or four
stitches.
Remove
work,
draw
threads to underside, fasten, and
trim.
23