M” stitch, Elastic insertion, Recommended settings – SINGER 6212 User Manual
Page 29: Lace insertion, Elastic insertion lace insertion, J i ||j
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
“M” STITCH
This stitch can be used for stretch seams and decorative stitching.
Elastic insertion
RECOMMENDED SETTINGS
Stitch Selection: “M“ Stitch #6
Needle Position: LGZU
Stitch Width: j 11|§
Stitch Length: 1 -2
Foot: Special Purpose (J)
Needle Plate: General Purpose (A)
• Fit elastic for snugness and allow 1
inch (25mm) for joining. Lap the two
ends and stitch.
• Divide elastic and garment into equal
quarters. Place elastic over the
fabric and pin the two together at
these points keeping top edges even.
• Anchor the elastic to the fabric with a
few stitches. Now stretch elastic
between the pins as you sew, using
both hands to hold elastic tight in
front and back of presser foot.
Lace insertion
Lace is inserted after fabric is cut,
but before it is sewn together.
RECOMMENDED SETTINGS
Stitch Selection: “M” Stitch #6
Needle Position:
LEU
Stitch Width:
j I ||j
Stitch Length: 1/2-2
Foot: Special Purpose (J)
Needle Plate: General Purpose (A)
Cut lace to desired size.
Position lace on right side of fabric
and pin in place.
Place the work under the presser
foot so that the stitches fall over the
lace edges, as shown.
After both sides of lace are sewn,
turn fabric over to the back side and
cut the fabric on both sides close to
the stitching lines and remove.
27