Zig-zag stitching, Stitch pattern selector, Needle position selector – SINGER 6212 User Manual
Page 22: Stitch width selector, Section 4. zig-zag stitching
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. ZIG-ZAG STITCHING
STITCH PATTERN
SELECTOR
Before moving pattern selector,
make sure needle is fully raised.
• The stitch pattern selector, located
on the control panel, controls stitch
selection.
• To select a pattern, slide pattern
selector under the desired stitch.
NEEDLE POSITION
SELECTOR
Before moving selector, make sure
needle is fully raised.
• Most of your zig-zag stitching, will be
done in the center ( ^ ) needle
position.
• Left (
^
) and right ( * ) settings
are u s e d f o r s p e c i a l s t i t c h
placement.
STITCH WIDTH SELECTOR
Before moving selector, make sure
needle is fully raised.
• To produce any of the zig-zag
stitches, the stitch width selector is
moved from its straight position
( j )to any of its other four posi
tion s. The further you move the selec
tor lever toward the right, the wider
your stitch will be.