Replacing slide plate, Changing the light bulb – SINGER 6105 User Manual

Page 41

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

REMOVING FACE PLATE

REPLACING SLIDE PLATE

Loosen screw A (do not remove).
Loosen face plate screw B then remove

face plate by drawing it toward you. Re

place face plate by sliding top edge of

plate under edge of arm top cover. Tighten
screws B and A.

Place slide plate in slide way with the front
edge close to. but not covering, the retain

ing spring C. With a small screwdriver, lift
each end of the spring into each of the side

grooves on the under side of the slide plate.

Draw the slide plate gently toward you to

fully engage the spring. Close slide plate.

CHANGING THE LIGHT BULB

CAUTION: Boforo changing light bulb make

sure you have disconnected power line plug

from socket outlet.

CAUTION: This machine is designed to use
a 15 watt maximum bayonet base bulb only.

Removing Bulb

Replacing Bulb

• Remove face plate.

• Do /

1 0

/ attempt to unscrew the bulb.

•

Press it up into the socket and at the

same lime turn bulb over in direction

shown to unlock the bulb pin and guide

out of socket.

• Press new bulb into socket, with bulb

pins entering slot of socket.

• Turn it over in direction shown to lock

bulb in position.

• Replace face plate.