Threading the machine – SINGER 6105 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

threading the machine
•
Raise the presser foot to release tension
discs and make sure needle and take-up
lever are in highest position.
•
Place spool pin felt from accessories over
spool pin, and place spool of thread on
spool pin over felt, with spool thread re
taining slit A on top.
•
Keep right hand on spool of thread to hold
firmly in place while threading machine.
• Snap thread Into upper thread guide 1.
• Pass thread through point 2.
•
Thread the needle thread tension 3. Slide
thread over metal plate into tension discs.
Lead
thread
under
needle
thread
tension
and through tension wire by firmly pulling
thread straight up.
•
Pull thread to right behind point 2 guiding
thread up toward take-up (ever.
• Pass thread through points 4 to 6 as shown.
•
Thread needle from front to back and draw
about 10 cm (4 inches) of thread through
eye of needle.
I3