SINGER 6105 - Manual (Page 36)

i I
buttons
• Pattern Group Selector; /
L\ 1 J. • Needle Position:
• Stitch Width: To suit button
• Stitch Length: 0
• Snap-in Feed Cover
• General Purpose Foot
ATTACHING A BUTTON
Flat buttons can be sewn on by machine using
the zig-zag stitch.
• Attach snap-in feed cover to general pur­
pose needle plate.
1. Set stitch width selector at * *.
• Set needie position at left i,.
• Place button positioned on fabric under
foot and lower needle into centre of left
hole.
• Lower presser foot.
• Turn hand wheel toward you until the ne­
edle rises out of button hole and is just
above the presser foot.
2. Set stitch width selector to a medium width
zig-zag setting.
• Continue turning hand wheel until the
needle is above right hole, adjust stitch
width, as necessary, until needle enters
the centre of the right hole.
• Take six or more zig-zag stitches and
finish with the needle on the left.
3. Move stitch width selector to \ and take a
few stitches to fasten threads.
• Pull thread ends through to back of gar­
ment knot close to fabric and snip off
loose ends of thread.
34