SINGER W616 - Manual (Page 28)

ADJUSTING AND CHANGING “V” BELT
2 9
f l
0
iniiii -rnift
.4
Fig. 57
Fig. 58 Fig. 59
Following are the instructions for adjusting and changing the "V” belt;
) Remove three screws holding rear cover (Fig. 59 ) and fip it out at the bottom Then
pivoting around the hand wheel away from the front of the machine.
2) To adjust V belt, loosen screws (A, Fig. 58) and move bracket B up to loosen bell and
down to tighten,
^3) To remove "V" bell:
(A) Remove lop cover,
(B) loosen screws A" (Fig. 58) and move bracket “ b ” to its highest position.
(C) Slip bell off motor pulley and then over hand wheel.
(D) Replace V bell by slipping it over hand wheel and then over motor pulley
(E) Adjust as noted under No. 3 .