Preparing to sew, Removing the work – SINGER W616 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

I >

PREPARING TO SEW

Have Itike-up lever at highest point before starting to sew. Do not try to help the feeding

by pulling the material as this may deflect the needle and cause it to break.

NEVER run machine without material under presser foot.

place material and threads in position under the presser foot and lower the presser foot. You

ate now ready to begin sewing. By having the needle at its highest point, it is not necessary

to touch the hand wheel to start the machine. You merely press the control. The ispeed of the

tnachine is regulated by increasing or decreasing the amount of pressure exerted on the control.

REMOVING THE WORK

21-A

Be sure to stop the machine

when the thread take-up lever and

needle bar are at the highest po

sition.

Now raise the presser foot and

draw the fabric back and to the

left (Fig. 21, B) and pass

the threads over the thread cutter.

Pull down slightly, holding thread

in both hands, so as not to bend

the needle.

Leave the ends of thread under

the presser foot.

Fig. 21-B