Setting the needle – SINGER W1366 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 6
SETTING THE NEEDLE
See Fig. 6. Raise the needle bar A to its highest
point, turning wheel toward you by hand.
Then loosen the needle clamp screw B and the
needle can be inserted into clamp C. Place needle
(flat side to right} in the needle clamp and push it
upward as far as it will go into the needle clamp
hole, tightening the needle clamp screw securely
with a screw driver.
After
changing
the
needle
make
one
com
plete
revolution
of
the
balance
wheel
by
hand
to
be
sure
the
needle
is
in
the
correct
position.
THREADING THE BOBBIN CASE
Flat surface
of needle
shank
/
Fig. 7
Step 1 iillustrated in Fig. 8). Hold bobbin case between thumb and forefinger of left hand,
so that the slot in the edge of the bobbin case is on top. Take the bobbin between thumb and
forefinger of right hand so that the thread on top leads from left to right.
Step 2 Insert bobbin into bobbin case, pull the thread into the slot of the bobbin case as
shown in Fig. 9, and draw it under tension spring and into the fork-shaped opening of the spring
as shown in Fig. 10