Binder, Folded binding (fig. 69), Two-tone binding (fig. 70) – SINGER W1366 User Manual
Page 37: Hand-cut bias binding (fig. 69)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

oo
B I N D E R
This attachment folds bias binding and applies it to the edge of material in one operation.
Slots on scroll of the binder are for corresponding widths of commercially folded bias binding.
The open mouth of binder scroll is used for unfolded bias strips cut 15/16 inch wide.
FOLDED BINDING (Fig. 69)
Cut a point on folded binding, insert in appropriate
slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or left.
TWO-TONE BINDING (Fig. 70)
Two bindings can.be sewn on fabric edge also in one
operation. When two are used, always skip one size be
tween widths, inserting each in correct size slot.
HAND-CUT BIAS BINDING (Fig. 69)
Cut 15/16 inch bias binding fold in half for a couple
of inches. Cut binding diagonally toward end, almost to
fold. Slip fold into center of binder. Draw back until
cut opens and binding encircles open end of scroll. Test
stitching
to be sure it is on the edge, adjust if
necessary.
See Figs.
67
and 68 for
suggestions
on how to use
the binder.
There are
hundreds of
ether uses.
Fig. 69
Fig. 68
Fig. 70