Replacing bobbin case, Changing the light bulb, Removing bulb – SINGER 7184 User Manual
Page 65: Replacing buib
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING BOBBIN CASE
Raise needle, open slide plate, remove needle
plate and lift out bobbin.
Turn bobbin case holder A to back as far as it
will go.
Lift out bobbin case B.
REPLACING BOBBIN CASE
Insert bobbin case with a back and forth mo
tion, so that front of the case is under the po
sition plate C. Turn holder all the way forward
to lock bobbin case.
Replace needle plate and close slide plate.
CHANGING THE LIGHT BULB
CAUTION: Before changing light bulb make sure
you have disconnected power line plug from
socket outlet.
CAUTION: This machine is designed to use a 15
watt maximum bayonet base bulb only.
1. Removing Bulb
• With thumb of right hand push in and down on
tab of light lens and lower the light bracket.
• Do not attempt to unscrew the bulb.
• Press it up into the socket and at the same
time turn bulb over in direction shown to un
lock the bulb pin and guide out of socket.
2. Replacing Buib
• Press new bulb into socket, with bulb pins
entering slots of socket.
• Turn it over in direction shown to lock bulb
in position.
• Push entire assembly up until it snaps in
position.
63