Removing and replacing top cover, Removing face plate, Replacing slide plate – SINGER 7184 User Manual
Page 63
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING AND REPLACING
TOP COVER
• Raise handle.
• To remove top cover, loosen and remove
screws A and screws B, positioned under
the handle, and lift it.
• To replace cover; replace and tighten screws.
REMOVING AND REPLACING
BOTTOM COVER
(model 7174 only)
• Tilt machine over on its back and remove
screws C from the bottom cover. Remove
cover from machine.
• Replace by fitting bottom cover to machine,
then replace and tighten screws C.
REMOVING FACE PLATE
Loosen screw D (do not remove).
Remove face plate screw E then remove face
plate by drawing it toward you. Replace face
plate by sliding top edge of plate under edge
of arm top cover. Tighten screws E and D.
REPLACING SLIDE PLATE
Place slide plate in slide way with the front
edge close to, but not covering, the retaining
spring F. With a small screwdriver, lift each
end of the spring into each of the side grooves
on the under slide plate. Draw the slide plate
gently toward you to fully engage the spring.
Close slide plate.
61