SINGER W166 - Manual (Page 36)

54
B I N D E R
This attachment folds bias binding, applies it to the edge of
material in one operation. Slots on scroll of the binder are for
corresponding widths of commercial folded bias binding.
The open mouth of binder scroll is used for unfolded bias
strips cut 15/16 inch wide.
FOLDED BINDING (Fig. 41)
Cut a point of folded binding, insert in appropriate slot. Draw
through slot and under binder with strong pin. Sliding binder
slot to right or left.
TWO-TONE BINDING (Fig. 41)
Two bindings can be sewn on fabric edge also in one operation.
When two are used, always skip one size between widths,
inserting each in correct size slot.
HAND-CUT BIAS BINDING (Fig. 42)
Cut 15/ 16 inch bias binding fold in half for a couple of
inches. Cut Binding diagonally toward end, almost to fold.
Slip fold into center of binder. Draw back until cut opens
and binding encircles open end of scroll. Test stitching to be
sure it is on the edge adjust if necessary.
:‘ig. 4 1
IS
ill!
un
ho
Io(
e;u
of
yoi
Fig. 4 2
HO
V / M