Removing the work, Creative embroidery – SINGER W166 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
14
REMOVING THE WORK
Be sure to stop the machine when the thread take-up lever
and needle bar are located at the highest position.
Now raise the presser foot and draw the fabric l,ack and to
the left, Fig. 21-A and B, and pass the threads over the thread
cutter.
Pull down slightly, holding thread in both hands, so as not to
bend the needle.
Leave the ends of thread under the presser foot.
CREATIVE EMBROIDERY
jg ^Цгe zigzag presser foot and zigzag needle plate are in place
The SATIN STITCH, Fig. 22,
----------------- -------------
which is really just a very short
zigzag stitch, and the basis for most
pj
2
‘>
embroidery, is obtained by setting the stitch lengUi as near 0 as
po-ssible without stopping the feeding action.
1 he width may he set anywhere from just ¡)ast 0 to the
widest, 4.
f-i«. -I H