SINGER W166 - Manual (Page 29)

27
1 .
2 .
3.
4.
5.
Clean the shuttle race, the shuttle, and shuttle race cover by removing all threads, lint, etc.
A|»ply a drop of oil with finger tip to outer edge of shuttle.
When the cleaning has been completed, proceed as follows to replace the shuttle assembly:
I urn the balance wheel until the needle reaches its highest position.
Place shuttle Itody, (D), against shuttle driver and adjust into position.
Replace shuttle race cover, (C), fitting pin at lower edge into notch, and lock into position with
shuttle race cover clamps, (B), making certain the clamps have been snapped securely into position.
Put bobbin into the bobbin case.
Put the bobbin case into the shuttle race, fitting tongue into notch(E)of race cover.
10 H
14
16 o„o
ACCESSORIES
1 Large screw driver
2 Small screw driver
3 Ripper
4 Quilter guide
5 Presser foot for
straight sewing
6 Buttonhole Fooi^tV-f
7 Thumb screw
8 Cloth Guide
9 Small Heinmer Foot
10 Cording Foot
11 Button sewing Foot
12 Package of Needles
13 Needle plate for
straight sewing
14 Sew Light Bulb
15 Plastic Oiler
16 Bobbins (3)
17 Felt Washers
(for spool pins)