Removing and replacing light bulb, To remove the light bulb, Cleaning the machine – SINGER 9124 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING AND REPLACING LIGHT BULB
CAUTION:
• Before changing light bulb, make sure you have removed plug from socket outlet.
Be sure to replace the face plate which covers the light bulb before operating the
machine.
• This machine is designed to use a 15-
watt maximum light bulb.
To change the light bulb, the face plate
must first be removed.
• Loosen and remove screw (1).
• Slide face plate down and away from
machine.
TO REMOVE THE LIGHT BULB
•
Push bulb up into socket (2) and turn
to the left to unlock bulb pins.
• Pull bulb down and out of socket.
TO REPLACE THE LIGHT BULB
•
Push new bulb up into socket and turn
to the right until pins lock into position.
• Reposition face plate by sliding top
edge of plate under edge of top cover.
• Line up screw hole in plate with screw
hole in machine.
CLEANING THE MACHINE
Your machine is designed to give you many years of dependable service. To ensure this
reliability, take a few minutes to keep the machine clean. How often you clean it depends
on how often you use it.
Using the lint brush, remove lint or dust
from:
Insert screw and tighten.
presser bar
needle bar
machine surface (if necessary,
dampen a soft cloth and use a
mild soap to clean the surface)
Remove needle plate as instructed and
clean exposed area with a lint brush.
- bobbin case (if there is a lot of lint
in this area, remove the bobbin
case for cleaning)
43