SINGER 15-91 - Manual (Page 62)

60
edge of the ruffle to the right of the attachment
as shown in Fig. 63.
The material for piping must measure about ^
inch wide when folded in the center and is usually
cut on the bias. Place the piping material in the
ruffler, following the line 4, in Fig. 59, with the
folded edge of the piping to the right. The material
to which the piping and ruffling are to be sewn
should be folded on the edge and inserted in the
ruffler, following the line 5, in Fig. 59.
To Adjust the Ruffler for Plaiting
Raise the adjusting lever (E, Fig. 64) and move
it to the right so that the projection (D, Fig. 64)
P ig . 64
will enter the slot marked “6” in the adjusting lever
when the lever is released. The ruffling blade will
then move forward and back once at every six
stitches. To adjust the ruffling blade to make a
plait once at every twelve stitches, place the adjust­
ing lever (E, Fig. 64) so that the projection (D)
enters the slot marked “12” in the adjusting lever.
Insert the material to be plaited, between the two
blue blades, following the line (2, Fig. 59). The size
or width of plaits is regulated by the adjusting screw