SINGER W761 - Manual (Page 21)

How to EmbroiJer with • Hoop
It is easy to follow a stamped design or to work free hand when
embroidering or monogramming. (See Figs. 33 and 34.)
Release the pressure from the foot by turning the burled nut
on the automatic darner in the direction of the arrow, or clock­
wise. Push the drop feed button down so that "E" appears
between the two buttons. Stretch the fabric in an embroidery
hoop, and place under the needle after removing the presser
foot. Set the stitch width at the size you prefer and lower the
presser bar lifter. Then operate the machine at a rather high
speed while moving the hoop slowly with both hands. Work
carefully and be sure to keep fingers out of the path of the
needle.
Fig. 33
J2 3 4 5 e7 S9
Fig. 34
Fig. 35
How to Use Attachmonts
1. Narrow hemmer. With the needle in its highest position
replace regular presser foot with narrow hemmer (Fig. 35).
For a plain narrow hem, make a 1, 8 inch double fold for about
two inches along edge of fabric. Hold each end of the two-
inch fold, slip underneath hemmer. Bring fold up into the
scroll of hemmer, draw forward to end and fasten with point
of needle. Lower presser bar lifter. Gently pull ends of thread
as you start stitching.
Guide material slightly to right, and it will automatically take
a double turn through scroll.
(
16
)
00 o
o
fN