How (o remove and replace bobbin cate – SINGER W761 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

How (o Remove and Replace Bobbin Cate

Fig. 16

To Thread (he Bobbin Cate

Raise the needle bar to its highest position

and lift up the hinged cover plate. Grasp the

bobbin case by the latch and pull out (see Fig.

16). When the latch is closed, the bobbin

falls out of the case readily.

To replace, hold case by latch and place it

on spindle in center of shuttle race. Press fir

mly before closing latch, making certain that

the tongue of the case fits into notch on the

upper edge of the race cover.

Fig. 18

Refer to Figs 17, 18, 19 and 20 to familiarize yourself

with the procedure. Hold the bobbin case in your left

hand with tongue pointing up.

Let about two inches of thread hang free from the bo

bbin, and insert bobbin into case, so that thread will be

rotating counter-clockwise.

Guide the thread end through the slot on the side of the

case and under the tension spring until it enters the

small notch on the edge of the spring.

( 9 )