To wind the bobbin – SINGER W761 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Good
To Wind the Bobbin
Turn the clutch nut in the center of
the hand wheel toward you to disen
gage the sewing mechanism. Place a
spool of thread on the spool pin, and
slip the thread through the upper arm
thread guide and across to the tension
disc as shown in Fig. 14.
Insert thread through a hole on edge
Fig. 14
of bobbin and place bobbin on spindle
of winder. Be sure that the notch in
the bobbin fits over the small pin on
the spindle. Press down on lever mar
ked "push" and set machine in motion.
When the bobbin is fully wound, the
action of the winder stops automati
cally. Remove from spindle and cut
■ ( 8 )
N o G o o d
Fig .1.5
N o G o o d
off loose thread end.
If the bobbin winds unevenly (see Fig.
L5), adjust the bobbin winding tension
disc to the right or left by loosening
the screw holding it to the bed of the
machine. Then tighten.
Before starting to sew again, tighten
clutch nut by turning it away from
00
o
o
rsi