Infpwiimfua gcjofes: i t, Lc .lo – Maytag MAH-3 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ROUBLESHOOTING

; iNfpWiiMfUa Gcjofes: i T;:

Information codes may be displayed to help you better understand what is occurring with the washer.

Code

Symbol

Meaning

Solotion

Unbalanced load prevented the N¥asher from
spinning.

Redistribute the load, press the Cycle Selector
dial.

Door is unlocked when washer is running.

Press Power Off pad then restart the cycle. If the

code reappears, call for service, see below.

Door is open when washer is running.

Close the door tightly and restart the cycle.
If the code reappears, call for service, see below.

The washer failed to lock the door.

Close the door tightly and restart the cycle.
If the code reappears, call for service, see below.

Water temperature control problem.
(Heater Control problem)

Cal! for service, see below.

.LO..

The washer has tried to fill but has not reached
the proper water level.

The door will not unlock.

Call for service, see below.

Make sure the door is firmly dosed.
Push the Power Off pad to turn off the washer, and

then turn it on using any pad. if the code reappears,
call for service, see below.

Motor not running properly.

Restart the cycle pressing the Cycle Selector dial.
If the code reappears, call for service, see below.

The washer is not draining.

See Troubleshooting “The washer does not drain

and/or spin”, page 13. If problem continues, call for

service, see below.

The washer has tried to fill but was unsuccessful.

Make sure the water faucets are open all the way.
Check for kinked hoses.
Check inlet screens on fill hoses.

Problem with control.

Call for service, see below.

Eiectric service was lost when washer was
running.

Restart the cycle by pressing the Cycle Selector
dial.

For any codes not listed above, call Maytag Customer Service at I -800-688-9900 USA or I -800-688-2002 Canada.

1 4