Setting the needle, Threading the bobbin case, Hold bobbin case between faxhto tetlef – SINGER W7013 User Manual
Page 8: Setting the needle threading the bobbin case
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 3
Step 1 iillustrated in. Fig. 4
SETTING THE NEEDLE
See Fig. 3. Raise the needle bar A to its highest point, turn-
inci wheel toward yon by hand.
i
Then loosen the needle clamp screw ®
be inserted into clamp C. Place needle i t l a t side „ t o n g ^
the needle clamp and push it upward as
the needle clamp hole, tigtemng the needle clamp sc
securely with a screw driver.
Alter changing the needle make
volution of the balance wheel by hand to be sure me
needle is in the correct position.
THREADING THE BOBBIN CASE
Hold bobbin case between
faXhto tetlef
Step 1 uiiusiraiea ni i- J-y-
__________ ___
so that the slot in the edge of the bobbin case is o P^^^
2. Insert
and forefinger of right hand
a
of the bobbin case as shown in Fig. 5,
bobbin into bobbin case, pull the thread
the fork-shaped opening of the spring as shown
and draw it under the tension spring and into the tork-siiapea op y
in Fig. 6.
^ ' i # ; ’
/ i 1
Fig. 4