SINGER W7013 - Manual (Page 11)

11
*
4) into check spring C . , , *
5) then tug on thread to pull it into hook D see insert,
Fig. XO). f
6 up into take-up lever E from back to front
7 down into thread guide F on face plate
8) through the needle bar thread guide fa
9 and into needle from left to right. Pull three or four
inches of thread through needle.
Hold the end of upper thread loosely and turn hand
wheel toward you until the needle goes all the way down
and comes back up. A loop (Fig. 11 j will be foiled ovw
the upper thread which then can be pulled out straight.
Place both thread ends under the slot of the presser foot
and draw toward the back of the machine, leaving both
threads three or four inches long.
SETTING THE STITCH LENGTH
Forward and reverse stitching are both regulated by
lever A Fig. 12. ,
To adjust the stitch length loosen screw B and move
to bottom of slot Move lever A to desired stitch length.
Red numbers indicate stitches per inch. Move screw B
in an upward motion until stop contacts lever A tight­
en screw "B". This will set the stops for both forward
and reverse stitching.
To sew in reverse move lever A in an upper motion
until it contacts stop. , , ,, • • i
For forward sewing return lever A to the original posi­
tion.
Fig. 11
Fig. 12