beautypg.com

Caution – Maytag MC2 User Manual

Page 32

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

g. The microprocessor (computer) board's L.E.D. display must read "DOOR."

h. Close the main door and restart the dryer.

i. Functional check of microprocessor (computer) board is complete.

2. Direct Spark Ignition (DSD System

a. Upon completing installation of the replacement

Direct Spark Ignition (DSI) module, reestablish
power to the dryer.

b. Start the drying cycle.

c. The ignition (DSI) module's L.E.D. indicator will

light "red" for up to approximately 1.5 seconds
(prepurge time).

d. The module's indicator light will then turn

"green". The gas valve will be energized and

the ignitor probe will spark for approximately 8

seconds. The burner flame should now be
established.

e. With the burner flame on, remove the flame

sensor wire from the FS terminal of the DSI
module.

f. The burner flame must shut off and the ignition

module must lock out with the DSI module's
indicator light "red".

g. Stop the drying cycle, with the flame sensor wire

still removed, restart the drying cycle.

h. The ignition module must proceed through the

prepurge, with the indicator light "red", the
ignition trial time of approximately 8 seconds,
with the indicator light "green", and then
proceed to lock out with the indicator light "red".

Indicator

Amerloan Dryer Corp.

^ ADC P/N 880815

• MODEL MIL - 1

О

I

Red - Power Established!

-jOreen- Ignilion Sequence]

¡Qreen - Flame Confirmed |

Red - Ignilion Failed

Conirol Locked Oul I

STATUS

If red indicator is "On" continuously,
discontinue power for 30 seconds
and then reestablish power. If red
indicator slill remoins "On”
continuously, replace control.

Direct Spark

Ignition Control

FOR USE WITH ALL GASES
Input: 24 VAC 50/60HZ 1 Amp
contacts: 1 Amp Continuous
Prepurge: 1.5 Seconds Mox.
Trial For Ignition 8 Seconds Max.
Lockout: 10 Seconds Max,

WARNING I

Disconnect Power Before Servicing,

NOT FIELD REPAIRABLE. Explosion and

Serious Injury Moy Result |—,

□ □ □ □

,V3T /

Ox

i. Functional check of the Direct Spark Ignition (DSI) Module is complete.

1) Replace the flame sensor wire from the FS terminal to the DSI module.

CAUTION

LABEL ALL WIRES PRIOR TO DISCONNECT WHEN SERVICING THE COMPUTER
BOARD AND THE IGNITION MODULE. WIRING ERRORS CAN CAUSE IMPROPER
AND DANGEROUS OPERATION.

28