Maytag MC2 - Manual (Page 26)

1. The controls of a timer model dryer consist of;
B. MECHANICAL TIMER CONTROLS (non-computer)
Component
Drying Time
Cool-DownTimer
Heat Selector Switch
"Push to Start" button
Function
Permits the dryer to run in the heating mode for a maximum time of 60
minutes.
Permits the dryer to run in the cool-down mode for a maximum of
15 minutes. Cool-down time starts at the conclusion of the drying time.
Controls the temperature during the drying cycle. Selections available
are high temp., low temp., and permanent press.
Safety Device which must be manually "pressed" to start the dryer.
Whenever the dryer is stopped by opening the main door during a cycle,
the "Push to Start" button must be pressed to restart the dryer.
Indicator Light Lights to indicate that the dryer is in the drying or cooling cycle.
2. Operating Sequence
a. Turn drying timer knob to desired drying time. Turn cool-down timer knob to desired cool-down time.
b. Make temperature selection in accordance with the type of material being dried.
c. To start unit, press "Push to Start" button.
NOTE; Main door #««5/closed.
d. The dryer will start and the heat circuit will activate. The indicator light will come on.
e. The heat will come on and stay on until the tumbler reaches the temperature setting of the selected
thermostat. The thermostat will open shutting off the heat. As the tumbler temperature cools, the
thermostat will reclose, turning on the heat. The dryer will operate in this manner for the duration of the
dryingtime. At the completion of the dryingtime, the cool-downtime will start. The dryer will run without
heat for the duration of the cool-down time.
22