Maytag MC2 - Manual (Page 27)

C. PPL COMPUTER MODELS (non-computer)
NOTE: The programs have been pre-set at the factory, for changes in the program consult the
User's Manual or contact the distributor.
MAN3728
Manually Operated Timed Mode
1. When turning on power, or when no cycle is in progress, the L.E.D. display will read "FILL".
2. Press key number 5.
3. Select cycle drying time. Display will read "Ld—". Enter the drying time desired in the two blank spaces.
Press enter/start key.
4. Select cycle cool down time. Display will read "LC-". Enter the cool down time desired, in the two blank
spaces. Press enter/start key.
5. Select cycle drying temperature. Display will read "F—". Enter the drying temperature desired in the three
blank spaces. Press enter/start key.
6. (For reversing dryers in select reverse mode only). Display will read "Sr--". Press enter/start to begin a
reversing cycle and 0 to begin a non-reversing cycle.
7. Upon completion of drying and cooling cycles, the tone will sound and the display will read "donE" at which
time the dryer will shut off.
a. NOTE: If the anti-wrinkle program is active, the display will remain reading "donE", and the
computer will proceed through the anti-wrinkle program until the maximum Guard On
Time has expired or until the door is opened, whichever, comes first. The display will
read "FILL".
b. NOTE: If the anti-wrinkle program is not active or in use, the display will read "donE" until the
door is opened.
23