Preparation for threading – SINGER 14U285B User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. Preparation for threading
• Setting up the thread guide holder
Extend the thread guide holder as far as possible
and set the thread guides so that they are located
right above the spool pins.
Place the thread on the spool stand as shown in the
figure at the left.
When using synthetic threads that easily spill off the
cone, slip the anti-spill sleeve furnished with the
machine over the thread from the bottom of the
cone leaving the thread end hanging free at the top
of the anti-spill sleeve as shown above.
When using a regular thread spool, fit the
spool cap supplied with the machine onto
the thread spool as shown at left.