SINGER 14U285B User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(2) Thread the left looper (yellow path)
Remove cylinder cover and thread left looper in the order (T) to (||) shown below. (Yellow thread
path) (See page 9 for cylinder cover removal)
While
holding thread w/ith finger,
pass it between the tension discs
and pull thread down to make
certain it is properly located in
between the tension discs.
Turn hand wheel toward you
until left looper is at left as far
as it will go and thread the
looper thread hole (9) from left
to right. (Use tweezers provided
in your accessory set).
Turn hand wheel toward you
until the looper is at right as far
as it will go passing the thread
under the throat plate, then
using the tweezers, thread the
looper thread hole (Q) from
front to back.
Place the thread over the top of the right looper and
hold the thread while initially sewing.
15