SINGER 14U285B - Manual (Page 8)

4. Preparation for sewing
Connect the machine plug to the electrical receptacle of your machine and the power line plug to the wall
receptacle.
For 220/240V
Power switch
(used also for light switch)
Push upper side ("I" mark)
to turn "ON".
Push lower side ("O" mark) is visible
to turn "OFF..
For 120V
Power switch
(used also for light switch)
When the switch is ON,
the red mark on the knob
Power line plug
Wall receptacle
To run the machine and control the speed, press the speed controller. The harder you press, the faster the
machine will sew. To stop the machine from sewing, remove your foot from the speed controller.
Caution:
® Be sure that the electrical voltage of the socket outlet (wall receptacle) is the same as the rated voltage
of the motor.
® Handle the foot controller with care and avoid dropping it on the floor. Be sure not to place anything
on top of it when not in use.
® Disconnect the power-line plug from the socket outlet when changing needles, presser feet or throat
plates, or when leaving the machine unattended. This eliminates the possibility of starting the machine
by accidentally pressing the speed controller.
• Before cleaning your machine, disconnect the power-fine plug from the socket outlet.