Threading, Threading the machine – SINGER 1036 Creative Touch User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
threading the machine
THREADING
• Raise take-up lever to its highest position by
turning hand wheel toward you. Raise
presser foot to release the tension discs.
1. Lead thread from spool holder and snap it
down into thread guidepost A.
2. Raise console cover and thread the rear thread
guide by holding thread in left hand and guiding
it over wing B and into channel C.
3. Draw thread firmly between tension discs,
down right-hand channel, and up left-hand
channel.
4. Thread take-up lever D by guiding thread
down over top of lever and then up into
eyelet.
5. Lead thread from take-up lever down into
left channel and then into lower thread
guides E and F.
• Thread the needle from front to back and
draw about 4 inches (10cm) of thread
through eye of needle. A needle threader
may be purchased separately at your local
Singer Sewing Center.