The set of hemmers, Hemmer set – SINGER W1166 User Manual

Page 39

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

THE SET OF HEMMERS

Before attaching any of the hemmers. Be sure

bobbin thread is pulled up. Then, with hemmer in

place, hold top thread loosely and turn handwheel one

full turn toward you, making a loop under hemmer.

Grasp bobbin thread with both hands and shp

horizontally under hemmer toward back. Bobbm

thread will catch loop and carry upper thread to back

of hemmer.

Fold mateiial to suit for two inches along edge,

ut. Fold hem to n.lri.1 bach of hemmer. I’”"

and fasten with point of needle. Pull on threads gently as you start strtchx g.

Fig., 71

H E M M E R S E T

You can make a hem 1/4', 3/8', 5/8' or 7/8' in width, depending upon

which hemmer you use. For a few of the m.nv uses see Fig. 72, 73, 74, 7b,

76 and 77.