SINGER W1166 - Manual (Page 38)

B I N D E R
This attachment folds bias binding, applies it to the edge of material in one oneratmt,
on scroll of the binder Me for corresponding widths of commercial folded bias bii^ina ’
The open mouth of binder scroll is used for unfolded bias strips cut 15/16 inch wide
FOLDED BINDING (Fig. 69)
Cut a point on folded binding, insert in appropriate
slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or. left.
TWO-TONE BINDING (Fig. 70'
Two bindings can be sewn on fabric edge also in one
operation. When two are used, always skip one size be­
tween widths, inserting each in correct size slot.
HAND-CUT BIAS BINDING (Fig. 69^
Cut 15 16 inch bias binding fold in half for a couple
of inches. Cut binding diagonally toward end, almost to
fold. Slip fold into center of binder. Draw back until
cut opens and binding encircles open end of scroll. Test
stitching to be sure it is on the edge adjust if necessarv.
See Fig. 67
and 68 for
suggestions
on how to use
the binder.
There are
hundreds of
other uses.
37
Slots
Fig. 69
Fig. 68 Fig. 70