Cisco OL-12997-01 - Manual (Page 5)

B-5
Cisco IPICS Server Administration Guide
OL-12997-01
Chapter B Setting Up and Using a Cisco Unified IP Phone as a Cisco IPICS Push-to-Talk Device
Moving the Logout Softkey Location on a Cisco Unified IP Phone
Step 5 Enter this command to save your configuration:
Router# write running-config startup-config
Step 6 Log out of the Cisco IOS router.
Moving the Logout Softkey Location on a
Cisco Unified IP Phone
When a Cisco Unified IP Phone user finishes using the Cisco IPICS service, the
user presses the Logout softkey on the phone. By default, a user must press the
Back softkey after exiting a channel or VTG to access the Logout softkey.
However, you can configure a phone to display the Logout softkey when a user is
connected to a channel or VTG. To do so, add the following parameter to the
Cisco IPICS Service URL:
buttonLayout=logoutOnPTT
Note If you configure this parameter, a user may need to press the More softkey on
some phone models to see Logout.
Subscribing to the Cisco IPICS Service
Cisco Unified IP Phone users in a deployment that includes Cisco Unified
Communications Manager must subscribe to the Cisco IPICS service before they
can access the service from a phone.
The information in this section does not apply to users in a deployment that
includes Cisco Unified Communications Manager Express. Cisco Unified
Communications Manager Express supports one active service and users are
subscribed to that service automatically.
Before a user can subscribe to the Cisco IPICS service, the service must be
configured as described in the
“Configuring Cisco IPICS as a Phone Service for
Cisco Unified Communications Manager” section on page B-2 .