Sears 247.8867 - Manual (Page 10)

4, With the traction drive clutch lever released, use
the speed select lever to set desired speed. Use
a slower ground speed for wet, heavy or deep
snow. Reduce speed if the wheels slip. Operate
the engine at full throttle for maximum efficiency.
A i
WARNING t
Be certain the traction drive clutch
lever is released before moving the speed
select lever.
5. Making certain no bystanders or obstacles are in
front of the unit, engage the auger drive clutch
lever {located on left handle).
6. Engage the traction drive clutch lever, located on
the right handle. As the snow thrower starts to
move, maintain a firm hold on the handle, and
guide the snow thrower along the path to be
cleared. Do not attempt the push the snow thrower.
To stop the forward motion, release the traction drive
clutch lever. Release the auger drive clutch lever to stop
the snow throwing action.
Operating Tips
1. For most efficient snow removal, remove snow im­
mediately after it falls.
2. Discharge snow downwind whenever possible.
Slightly overlap each previous swath.
3. Set the skid shoes 1/4" below the scraper bar for
norma) usage. The skid shoes may be adjusted up­
ward for hard-packed snow. Adjust downward (rais­
ing the scraper bar) when using on gravel or
uneven surfaces.
4. Be certain to follow the precautions listed under
“To Stop Engine" on page 9 to prevent possible
freeze-up.
5. Clean the snow thrower thoroughly after each use.
MAINTENANCE
A
t WARNING t
Disconnect the spark plug wire before performing any
repairs or maintenance.
MAINTENANCE
/
CHECK LIST
A /
/a A t /
/rS? / V' / j C
/ / / / /^/ /
SERVICE RECORD
IN DATES
'
COMPLETE
REGULAR SERVICE
Check Engine Oil
• • •
Change Engine Oil • • •
Tighten All Bolts and Nuts
• •
Check Adjustment o1 Clutch Cables •
Check Spark Plug • •
Adjust Drive Belts
• • •
Lubricate Pivot Points (see below) • • •
Lubricate Drive Cham
• •
Check Fuel
•
Drain Fuel •
10