To adjust gauge wheels {see fig. 7), To operate on hills, To operate mower (see figs. 5 and 6) – Sears 917.25049 User Manual
Page 14: To transport (see figs. 5 and 9), Operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
TO ADJUST GAUGE WHEELS {See Fig. 7)
•
Adjust mower to desired cutting height,
•
Lower mower with lift control. Remove rear retainer
spring and clevis pin which secure each gauge wheel.
•
Lower gauge wheels to ground. Raise gauge wheels
slightly to align holes in bracket and gauge wheel bar
and insert clevis pins. Gauge wheels should be slightly
off the ground,
•
Replace retainer springs into clevis pins.
TO OPERATE ON HILLS
TO OPERATE MOWER (See Figs. 5 and
6
)
Your tractor is equipped with an operator presence sens
ing switch. Any attempt by the operator to leave the seat
with the engine running and the attachment clutch engaged
will shut off the engine.
•
Select desired height of cut.
•
Lower mower with attachment lift control.
•
Start mower blades by engaging attachment clutch
control.
TO STOP MOWER BLADES
clutch control.
disengage attachment
A
CAUTION: Do not operate the mower
without either the entire grass catcher,
on mowers so equipped, or the dis
charge guard in place.
A
CAUTION: Do not drive up or down
hills with slopes greater than 15° and
do not drive across any slope.
. Choose ,hes,owes, speed before starting op or down
•
Avoid stopping or changing speed on hills.
•
if slowing is necessary, move throttle control lever to
slower position.
•
If stopping is absolutely necessary, push clutchitirake
pedal quickly to brake position and engage parking
brake.
•
Move motion control lever to neutral (N) position.
IMPORTANT:
THE MOTION CONTROL LEVER DOES
NOT
RETURN
TO
NEUTRAL
(N)
POSITION
WHEN
THE
CLUTCH/BRAKE PEDAL IS DEPRESSED.
•
To restart movement, slowly release parking brake and
ciutch/brake pedal
•
Slowly move motion control lever to slowest setting.
•
Make all turns slowly,
TO TRANSPORT (See Figs. 5 and 9)
When pushing or towing your tractor, be sure to disengage
transmission by placing freewheel control in freewheeling
position. Free wheel control is located at the rear drawbar
of tractor.
•
Raise attachment lift to highest position with attach
ment lift control
•
Remove retainer spring from freewheel control rod.
•
Push control rod in to disengage transmission and
reinsert retainer spring into control rod hole now on
back side of the bracket.
•
Do not push or tow tractor at more than two (2) MPH.
•
To reengage transmission, reverse above procedure,
NOTE: To protect hood from damage when transporting
your tractor on a truck or a trailer, be sure hood is closed
and secured to tractor. Use an appropriate means of tying
hood to tractor (rope, cord, etc.).
14
F1G.3