Sears 502.25502 - Manual (Page 9)

ASSEMBLY
HOW TO ASSEMBLE
THE STEERING WHEEL
Use the fasteners shown below to install the steering wheel The
fasteners are shown at fu!i size
Make sure the front wheels point forward. Slide the bellows
over the steering post. Make sure the collar of the bellows is
on top Push on the top of the bellows
Attach the steering wheel to the steering post with the fas­
teners as shown. Tighten the fasteners
HOW TO ATTACH THE HUB CAPS
Push each hub cap onto the center hub of each wheel Make sure
the washer holds the hub cap in place
CHECK THE TIRES
Check the air pressure in the tires. Tires with too much air pressure
will cause the unit to ride rough Also, the wrong air pressure will
keep the mower housing from cutting level. The correct air
pressure (PSD for each Rear Wheel is 14 PSI (10 kg/cm2) and for
each Front Wheel the air pressure is 24 PSI (1 6 kg/cm2). Models
that have semi-pneumatic front wheels will not have a PSI
F-92533
CHECK THE BELTS
Check the routing of the belts Make sure the belts are not twisted.
Make sure the belts are inside all the belt guides
The drive brake can be easily checked as follows., Set the parking
brake. Move the shift lever to the neutral (N) position. Push the unit.
If the rear wheels rotate, adjust the drive brake. See "How To Check
And Adjust The Drive Brake"