beautypg.com

How to prepare and charge the battery, Assembly, Danger – Sears 502.25502 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

ASSEMBLY

HOW TO PREPARE AND
CHARGE THE BATTERY

NOTE; Before you install the battery, add the battery acid

(Electrolyte) and charge the battery.. Battery acid will damage

paint and parts,

WARNING: Read the instructions included with

the battery acid container. Protect your hands

and eyes from the battery acid. Use clothing that

will protect you.

1

If the vent caps are not installed on the battery, remove the

vent caps from the plastic bag, Read the instructions

included with the vent caps. Your unit will have one or the

other types of batteries as shown,

2

If metal tape covers the vents, remove the metal tape from

the vents Discard the meta! tape.

3

Pour battery acid into each battery cell until the battery acid

touches the bottom of the vent as shown. Do not add the

battery acid above the bottom of the vent. If you add too

much battery acid, the excessive battery acid will flow from

the battery when you charge the battery

4

Wait 20 to 30 minutes before you put the vent caps on the

battery. While you wait for the battery, you can continue with

the assembly of the unit

5

The level of the battery acid can drop below the vent

described in step 3 Add more battery acid until the correct

battery acid level is reached install the vent caps Wash the

top of the battery with water to remove any battery acid,

6.

Discard the battery acid container and any battery acid that

was not used as follows. Fill the container half full with water.

Add baking soda and mix together using a piece of wood.

Add more baking soda until the solution does not foam

Discard the solution and wash the container with water.

Destroy the container.

WARNING: When you charge the battery, do not

smoke. Keep the battery away from any sparks.

The fumes from the battery acid can cause an

explosion.

7 Use a 12 volt battery charger to charge the battery Charge at

a rate of 6 amperes for 1 hour

8. After the battery is charged, check the level of the battery

acid If the level of the battery acid falls, add water Do not

add battery acid to a charged battery or the result can be

an explosion.

9 The engine has a 3 amperes charging system. If you frequently

start the engine or frequently use the headlight (if equipped),

the battery will not stay fully charged. For longer life of the

battery, charge the battery every three months

Remove and discard
the metal tepe

Vent Cap

CUT AWAY VIEW

^

'.¡.г^гьЛ

"í'-X

'íj

V*

—' "yV*

F-92533

8

DANGER

BATTERY ACID WILL

CAUSE SEVERE BURNS

Contains sulphuric acid

Do not let thebattery acid come in contact with the skin, the eyes, or the

clothing

To prevent accidents neutralize the battery acid that was not used. To
neutralize, fill the container half full with water Add baking soda and
mix using a piece of wood until the solution does not foam Discard the
solution and wash the container with water Destroy the container

ANTIDOTE;

External - Wash the area with water, then wash with a solution of
water and sodium bicarbonate
Internal - Drink large amounts of water, milk, or milk of magnesia
Drink water mixed with the whites of eggs Call a Doctor immediately
Eyes - Flush with water for 1 5 minutes and then get immediate
medical help

.

POISION

- KEEP AWAY FROM CHILDREN -

0~SZ13