Sears QUICK GRIP PULSE 831.29788 - Manual (Page 5)

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires the included alien wrench |j and your own phillips screw­
driver I
I adjustable wrench t and scissors
^Ptilse Handrail Bolt (^)-2
Handrail Washer (16)-4
1/2‘ Screw (13)-2-
Extension Leg Screw (34)-2
Flange Nut (57)-2
\\ Handrail Bolt^SlhZ ^
3/4" Screw (91)-4
3/8" Washer (61)-2
31/2* Handrail Bolt (89)-2
1 . With the help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (41) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (36) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (34).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(41) are resting flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 13. Follow the instructions to lower the treadmill.
Position the Left Handrail (2) on the left Upright (14). The
lower end of the Left Handrail should be on the outside of
the Extension Leg (41) as shown. Thread a Handrail Bolt
(15) with a Handrail Washer (16) into the left Upright and
the Left Handrail. Do not tighten the Handrail Bolt yet
Attach the lower end of the Left Handrail (2) to the
Extension Leg (41) with a 31/2* Handrail Bolt (89), a 3/8*
Washer (61), and a Range Nut (57). Do not tighten the
Handraii Bolt yet