beautypg.com

Oven vent location, Arranging oven racks, Removing & replacing oven racks – Sears 790.93754 User Manual

Page 7: Setting surface controls, To operate the surface elements, Before setting oven controls

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Before Setting Oven Controls

Oven Vent Location

For models equipped with coiled surface elements, iheoven vent is located under

the left rear surface element. When the oven is on, warm air flows through the

left rear element. This venting is necessary for proper air circulation in the oven

and good baking results. DO NOT BLOCK THE OVEN VENT.

Arranging Oven Racks

ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO

OPERATING THE OVEN). Always use oven mitts when using the oven.

Removing & Replacing Oven Racks

To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on

the oven walls. Tilt the front of the rack upward and slide the rack back into place.

RECOMMENDED RACK POSITIONS FOR

BROILING, BAKING & ROASTING

Food

Rack Position

Broiling meats, chicken or fish

1,2 or 3

Cookies, cakes, pies, biscuits & muffins

3 or 4

Frozen pies, angel food cake, yeast, bread,
casseroles, small cuts of meat or poultry

5

Turkey, roast or ham

Roasting shelf

ELEMENT ON

Setting Surface Controls

To Operate the Surface Elements:

1. Place cooking utensil on the surface element.

OFF

9

8

2.

Push in and turn the surface control knob in either direction to the desired

setting. Start most cooking operations on a higher setting and then turn to a

lower setting to finish cooking. The control knobs do not have to be set exactly

on a particular setting. Use the settings as a guide and adjust the control knob
as needed.

3. When cooking is completed, turn the surface element off before removing the

pan. Note: The surface “Element On’’ indicator light{s) will glow when one or
more elements are turned on. A quick glance at these indicator Iight(s) when

cooking is finished is an easy check to be sure all surface elements are turned
off.

Note: See page 8 for suggested surface control settingsfor different types of

food.

CAUTION

Do not place plastic items such as salt and pepper shakers,

spoon holders or plastic wrappings on top of the range when it is in use.

These items could melt or ignite. Potholders, towels or wooden spoons could catch
fire if placed too close to the surface elements.

This manual is related to the following products: