Sears 790.93754 - Manual (Page 15)

Setting Warmer Drawer Controls
Removing and Replacing Warmer Drawer (If equipped)
To Remove and Replace Warmer (Warm & Ready™) Drawer
To Remove Warmer Drawer:
ACAUTION Turn power off before removing the warmer drawer.
2. Open the drawer to the fuily opened position.
3. On the right glide you will find a shield attached with a hex-head screw (see
figure 1). Using a 1/4’’ socket and ratchet remove the shield.
4. Locateglide leveron each side of drawer, pul! upon the ieftglide ieverand push
down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide (see figure 2).
3. Align the glide on each side of the drawer with the glide slots on the range.
4. Push the drawer into the range until levers “click” (approximately 2”). Pull the
drawer open again to seat bearing glides into position. If you do not hearthe
levers “click" orthe bearing glides do not feel seated remove the drawer
and repeat steps 2-4. This will minimize possibie damage to the bearing
glides.
NOTE: The Warmer Drawer will NOT operate while inihe Self-Clean and “Oven
Lockout” modes
^WARNING
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
1 5