Sears BODYLEFT 831.159412 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Carefully cut the wire tie attached to the Cable

(25). Wrap the loop of Cable from steps 4 and 5
around the 3 1/2” Pulley (27) as shown. Hold the

Pulley and the Pulley Covers (88) between the
indicated holes in the Selector Plate (19). Make

sure that the Pulley Covers are turned so the
small rims are inside the loop of Cable as shown.
See assembly step 9, and make sure that the
Cable Is routed exactly as shown.

Attach the Pulley Covers (88) and the 3 1/2”

Pulley (27) to the Selector Plate (19) with the 3/8”

X 2” Bolt (87) and a 3/8” Nylon Jam Nut (41).

The drawing at the right shows the correct route of
the Cable (25). Make sure that the Cable is

routed exactly as shown. Note: The letters indi

cate the order in which the Cable is routed around

the Pulleys.