Trouble-shooting and maintenance – Sears BODYLEFT 831.159412 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the BODYLIFT. Replace any worn parts immediately. The

BODYLIFT can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

HOW TO TIGHTEN THE CABLE

Woven cable, the type used on the BODYLIFT, can
stretch slightly when it is first used. If there is slack in
the Cable (25), the Cable should be tightened. First,

move the selector to hole position “1” (see HOW TO
SELECT A RESISTANCE SETTING on page 11).

Next, loosen the Adjustment Screw (81) near the

lower end of the Cable. Pull the end of the Cable until

there is no slack in the Cable, slide the adjustment

sleeve and the ball against the indicated 3 1/2” Pulley

(27), and retighten the Adjustment Screw.

If a replacement Cable (25) is needed, see ORDER
ING REPLACEMENT PARTS on the back cover of

this user’s manual.