Non 90° angle for fascia, Roof – Flex FLE Roof Edge User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NON 90° ANGLE FOR FASCIA
MEASUREMENT WORKSHEET FOR USE WITHOUT A PROTRACTOR
ROOF
1. CIRCLE APPROPRIATE "ROOF SIDE" TO INDICATE OUTSIDE MITER OR INSIDE MITER.
THIS DETAIL APPLIES FOR MITERS TIGHTER THEN 90° (ACUTE) OR WIDER THEN 90° (OBTUSE).
2. STARTING AT EITHER SIDE OF THE CORNER, MEASURE ALONG THE WALL EDGE A CONVENIENT
DIMENSION, SUCH AS 24" OR 36", DEPENDING ON JOB SITE CONDITIONS. PLACE A MARK ON
THE WALL AND RECORD MEASURED DIMENSION AS "DIM A" IN THE DRAWING ABOVE, REPEAT
PROCEDURE FOR THE OPPOSITE WALL, AS SHOWN ABOVE.
3. MEASURE STRAIGHT ACROSS FROM MARK TO MARK, AS SHOWN, AND RECORD THE MEASURED
DIMENSION AS "DIM B".
4. FAX THIS SHEET TO 610-916-9501 WITH ORDER.
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone: 800-969-0108
Fax:610-916-9501
DATE: 12/03/10
DRN BY: JJC
CKD BY: SAK
SHT.# OF
DWG# 28810-3433
C
detail
8
p: 800-969-0108
f: 610-916-9501