Rewind button, Tv-vcr button, Stop button – Philips MX2797B User Manual

Page 41: Channel scan buttons, Number buttons, Vcr system button, Power button, Vcr bi, Usinc; i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

UsiNc; I

1 1 1

;

imotk

VCR Bi

ttons

hen using the TV remote
with a VCR, first make

certain it is set to control your
VCR ( by the REMOTE CODE or
SEARCH method - see earlier
section).

deauM)

Press the VCR System

I button on the remote.

Point the top of the remote

toward the front of the VCR

(remote sensor window) when
pressing buttons.

RgtQrOjittoii

Hold the RECORD button down, and
then press the PLAY button to begin
a VOl recording. Press to Clear or
erase an incorrect VCR button entry
(i.e. Timer Program). Also could be

used to set a VCR Plus+ Timer
Recording.

Rewind Button

Press to rewind tapes. For some

VCRs you may need to press STOP
button fint then REWIND. In
playback mode, hold button down to
view picture moving rapidly in
reverse.

fawsg Button

Press to temporarily stop the tape dur

ing a playback, or recording. Press
again to release Pause.

TV-VCR Button

Press to the VCR position ("VCR"

indicator on the VCR will light) to

view the playback of a tape. Press
again to place in the TV position
("VCR" indicator on the VCR will go
OFF) to view one program while
recording another program.

When used with the TV the TV/VCR
button works as a source button. Each
press cycles the TV between charmels
3 and 4; the last view channel; and the
AUX or S-VIDEO Input mode. It is a
quick one-button way to select these
channels and modes (without directly

entering the TV’s Menu system.)

Play Patton

Press to playback a tape. Hold down
after pressing the RECORD button to
start a recording.

Stop Button

Press to stop the tape.

Fast FgrwardRuttQn

Press to rapidly advance the tape. For
some VCRs you may need to press
STOP first then FF. In Playback
mode hold button down to view the
picture moving rapidly in the forward
direction.

•Channel Scan Buttons

Press to scan up or down through
VCR channel numbers.

•Number Buttons

Ihess buttons for direct VCR channel

selections.

VCR System Button

Press to send remote commands to
the VCR.

Power Button

Press to turn the VCR ON and OFF.

r i

111

Remember, the VCR

! buttons on the remote will

not operate your VCR if those

feahires are not alre^y found on
your VCR remote control.

Note: All VCR functions
(particularly Search, Rewind, Fast
Forward, etc.) will operate the
same as with the original VCR
remote control provided with the
VCR.